When you deauthenticate a WGB record from a controller, all of the WGB wired Value greater than the wired client’s idle period. Seconds is a value between 10 and 1,000,000 Traffic loss, prevent the wired client from being removed from the bridge tableīy configuring the aging-out timer on the WGB to a large value using theīridge bridge-group-number aging-time seconds As a result, the traffic flow to the wired client fails.
Its bridge table, even if traffic is continuously being sent to the wiredĬlient. Send traffic for an extended period of time, the WGB removes the client from Plug a wired client into the WGB network after the WGB has roamed to anotherĬontroller (for example, to a foreign controller), the wired client’s IPĪddress displays only on the anchor controller, not on the foreign controller. Local switching with local authentication, if the parent AP is a Wave 2 AP Guidelines and Restrictions for Cisco WorkgroupĪironet WGBs are not supported if the parent AP is configured for FlexConnect This section contains the following subsections: That there are no clients associated and mapped to that interface and then To modify any ACLs, then you must disable all WLANs that are in theĬontroller or disable both the 802.11a and 80.11b networks. If you have to apply ACL to WGB during run time, do not modify the ACLĬonfiguration for interface in the controller during run time. WLAN and make sure that Aironet IE is enabled. To enable the WGB to communicate with the lightweight access point, create a Wired clients connected to a WGB inherit the WGB’s QoS and AAA override Therefore, we recommend that you physically secure the wired Instead, the WGB is authenticated against the access point to which itĪssociates. Wired clients connected to the WGB are not authenticated for security. WPA2+AES, LEAP, EAP-FAST, PEAP, and EAP-TLS authentication modes Point GUI, choose Workgroup Bridge for the role in radio network on the Is used to connect to the lightweight access point. Radios, you can configure only one for workgroup bridge mode. Cisco IOS releases prior to 12.4(3g)JA and Mode and is running Cisco IOS Release 12.4(3g)JA or later releases (on 32-MBĪccess points) or Cisco IOS Release 12.3(8)JEB or later releases (on 16-MBĪccess points). The WGB can be any autonomous access point that supports the workgroup bridge If the lightweight access point fails, the WGB attempts to associate to another access In 8.10 release, the following APs support WGB operational mode: 2800, 3800, 4800, Up to 20 wired clients are supported behind a This enables the wireless infrastructure to know the MACĪddresses of the WGB’s wired clients. The WGB mode is supported on autonomous IOS (WaveĪ Cisco WGB provides information about its wired clients via Internet Access Point
That permits it to associate with a wireless infrastructure, providing networkĪccess on behalf of wired clients. Restrictions for Non-Cisco Workgroup BridgesĪ workgroup bridge (WGB) is a Cisco access point that can be configured in a mode.Viewing the Status of Workgroup Bridges (CLI).Viewing the Status of Workgroup Bridges (GUI).(Optional) Configuring RSSI Threshold and CDR Threshold.Configuring DLEP Local TCP Port and Server Address.Configuring Vlan for BVI Under PRP Mode.Configuring Dummy IP Address for Radio Interface.Configuration of Roaming Coordination on a Single WGB.Dual Radio Parallel Redundancy Protocol Enhancement on WGB.Parallel Redundancy Protocol Enhancement on AP and WGB.Reliable WGB Downstream Broadcast for Multiple VLANs.Workgroup Bridge (WGB) Downstream Broadcast On Multiple VLANs.Guidelines and Restrictions for Cisco Workgroup Bridges.Troubleshooting Articles by Cisco Subject Matter Experts.Client Traffic Forwarding Configurations.
0 kommentar(er)
